The Slim Light Series features a 20 Ga. baked white enamel steel housing that is only 2 1/4" thick maximizing the available space allowed for your paint spray booth. The Slim Light Series is available in lengths of 3 & 4' with 2, 4 or 6 lamp options. The 3' fixtures are available in T8. The 4' fixtures are available in T5HO or T8. This series provides front door frame access with a paint spray cutoff switch when opened. ETL listed in the U.S. and Canada, the Slim Light Series has multiple listings for inside access. Must be mounted hinge side up when wall mounted. Lamps not included.
LISTINGS:
ETL listed for U.S. and Canada
Class I Division 2 Groups A,B,C,D
T3C (160 degree C) operating code
Class II Division 2 Groups F,G
T3C (160 degree C) operating code
(The Slim Light 420 & 440 in T8 are UL listed for Class I Division 2 Groups A, B, C, & D.)
Listed for locations having deposits of readily combustible paint residues.
UL 844 listed for Hazardous Locations
Meets UL 1598 standards for wet/damp locations
FEATURES:
20 Gauge steel construction with white baked enamel finish
which creates a durable, highly reflective finish.
The housing is a front access for convenient access, and the
2 1/4" depth minimizes the space needed in the paint spray booth for the fixture.
LENS:
3/16" clear tempered glass.
ELECTRICAL:
Paint spray cutoff switch in the front door frame.
Available in: 3 Ft. 25 watt T8.
4 Ft. 32 and 54 watt T8 or T5HO
Voltages of 120, 277, 347 & 480 volts.
OPTIONS:
All Options Ordered Separately
EM: Emergency battery backup ballast
120 or 277V MUST SPECIFY
5902: 8 Ft. 5-wire whip
Corner/hip mount #4714 - see page 95 (available for the 390440J-3546 fixture ONLY)
Lens and fixture preservation: lens film and blast booth lens cover - see page 125
NOTE:
Normally open magnetic switches are intended to be used to trigger a relay
(furnished by others) which disables the paint system. Because of the small
capacity of the switch a solid state relay is recommended. It may be desired
by others to utilize a separate power supply to segregate the relay
(furnished by others) from the lighting power supply.
The magnetic switch IS NOT designed to directly control light operation!
The magnetic switch is rated for 10 watts resistive at a maximum of 300 VAC.
CAUTION:
Overloading the switch circuits WILL cause failure.
LDPI, Inc. recommends having a certified electrician/engineer
review loads to ensure that overloading of switch does not occur.
|
